User`s guide

Rack Mounting the Autoloader 7

SuperLoader 3

Note: The rails within the rack have a hole pattern that repeats throughout the rail.

1 Install two clip nuts, 1.75 in. (44.45 mm) apart, onto each of the four rails of the

rack, making sure that you install each pair of clip nuts at exactly the same level (see

figure

2).

Figure 2 Installing Two Clip

Nuts

Outer covers

of the rack

Rail

Clip nut

1.75 in

(44.45 mm)

Clip nut

2 Select the long or short autoloader brackets (depending on the depth of the rack),

and then attach them to the rear of the autoloader (see figure

3). Use the long

autoloader brackets (72-A226-A) when the distan

ce from the front mounting rail to

the rear mounting rail is less than 30.25 in. (76.84 cm). Otherwise, use the short

autoloader brackets (72-A225-A).

Threaded holes require neither

cag

e or clip nuts to accept

mounting hardware.

Figure Description