User`s guide

6 Rack Mounting the Autoloader
SuperLoader 3 Quick Start Guide
Figure 1 Rack Mount
Hardware
Short autoloader
brackets (72-A225-A)
Support brackets
(74-60605-01)
Long autoloader
brackets (72-A226-A)
Support bracket screws
72-A348-A (4) or 90-60227-50 (4)
Rack Mounting the Autoloader
This section provides the steps for attaching the autoloader directly to the stationary
rails of a rack. Refer to table 1
for information on common rack hole types.
Table 1 Rack Hole Types
Figure Description
Cage nut
Clip nut
Square rack holes are the most
common type of rack holes.
They can accept either cage
nuts which mount from the
back of the rail or clip nuts
which clip on from the side of
the rack rail.
Clip nut
Through holes require clip nuts
to accept mounting hardware.