User`s guide

After the Installation 19
SuperLoader 3
Tape Drive Device Driver For the tape drive (within the autoloader) device driver, go to one of the following:
• For the LTO-2 drive, go to:
http://www.quantum.com/ServiceandSupport/
SoftwareandDocumentationDownloads/LTO-2Drives/Index.aspx#Drivers.
• For the LTO-3 drive, go to:
http://www.quantum.com/ServiceandSupport/
SoftwareandDocumentationDownloads/LTO-3Drives/Index.aspx#Drivers.
• For the HP LTO-4 SCSI drive, go to:
Software and Driver Downloads at the HP Web site.
• For the LTO-4 drive, go to:
http://www.quantum.com/ServiceandSupport/
SoftwareandDocumentationDownloads/LTO-4Half-Height/Index.aspx.
• For the LTO-5 drive, go to:
http://www.quantum.com/ServiceandSupport/
SoftwareandDocumentationDownloads/LTO-5Half-Height/Index.aspx.
• For the VS160 drive, go to:
http://www.quantum.com/ServiceandSupport/
SoftwareandDocumentationDownloads/DLTVS160/Index.aspx#Drivers.
• For the DLT-V4 drive, go to:
http://www.quantum.com/ServiceandSupport/
SoftwareandDocumentationDownloads/DLTV4/Index.aspx#Drivers.
•For the SDLT 600 drive, go to:
http://www.quantum.com/ServiceandSupport/
SoftwareandDocumentationDownloads/SDLT600/Index.aspx#Drivers.
• For the DLT-S4 drive, go to:
http://www.quantum.com/ServiceandSupport/
SoftwareandDocumentationDownloads/DLTS4/Index.aspx#Drivers.
After the Installation
From the front panel of the autoloader, use the menus to set the IP address (DHCP or
Static), Subnet Mask (if required), Gateway (if required), SNMP Server (optional), and
Time Server (optional).
The default IP address is 192.168.20.128.
The default login and password for the On-board Remote Manager is guest and guest.
For detailed information on the setup, operation, and administration of your system, see
the
Quantum SuperLoader 3 User’s Guide (PN 81-81317).