User`s guide

12 SCSI Bus Requirements
SuperLoader 3 Quick Start Guide
The Ethernet connector on the back panel allows you to connect to the autoloader
remote management interface.
Figure 9 Back Panel Overview
1 68-pin HD SCSI connectors (or a Fibre
Channel or SAS connector)
2 Fan vent
3 Power connector
4 Autoloader remote management Ethernet
port
5 Power switch
SCSI Bus Requirements
You must connect the SCSI autoloader to one of the following SCSI bus types (drive type
dependent):
• Ultra 320 SCSI-3, LVD/SE SCSI bus
• Ultra 160 SCSI-3, LVD/SE SCSI bus
Caution: The autoloader is not compatible with a High-voltage Differential (HVD)
SCSI bus. (Irreparable damage may occur by attaching an HVD device or
controller to a LVD/SE device or controller.)
General Information Your SCSI host adapter card must also support the SCSI bus type used to connect the
autoloader. If you use a LVD SCSI bus, use a host adapter card with a connection for a
high-density (HD) 68-pin cable.
4 Front panel LCD screen
5 Function keys
6 Left magazine (or blank)
7 Right magazine (or blank)