Quick Start Guide

Rack Mounting the Autoloader 7
SuperLoader
Note: The rails within the rack have a hole pattern that repeats throughout the rail.
1 Install two clip nuts, 1.75 in. (44.45 mm) apart, onto each of the four rails of the
rack, making sure that you install each pair of clip nuts at exactly the same level (see
figure 2).
Figure 2 Installing Two Clip
Nuts
2 Select the long or short autoloader brackets (depending on the depth of the rack),
and then attach them to the rear of the autoloader (see figure 3). Use the long
autoloader brackets (72-A226-A) when the distance from the front mounting rail to
the rear mounting rail is less than 30.25 in. (76.84 cm). Otherwise, use the short
autoloader brackets (72-A225-A).
Threaded holes require neither
cage or clip nuts to accept
mounting hardware.
Figure Description
Outer covers
of the rack
Rail
Rail
Rail
Clip nut
1.75 in
(44.45 mm)
Clip nut