Quick Start Guide

Unpacking the Autoloader 5
SuperLoader
5 Remove the foam insert from the magazine bay of the autoloader. Save the packing
materials in case you need to move or ship the autoloader in the future.
Note: If the cover must be taken off, there are 26 screws that need to be removed.
Checking Accessories The following accessories are shipped with the Quantum SuperLoader 3:
• Quantum SuperLoader 3 Quick Start Guide
• SCSI tape drive kits
• SCSI host or server cable
• SCSI terminator (not included with Serial Attached SCSI)
• Fibre Channel tape drive kits
• Fibre Channel cable
• Ethernet cable
• Hardware to rack mount the autoloader (see figure 1)
• Four autoloader brackets (two long and two short to accommodate different
rack depths)
• Two support brackets
• Two sets (decimal and metric) of four support bracket 10-32 x 1/4 inch button
head screws (two per support bracket)
• TORX
®
L-Key drivers (T8 and T10)
• One magazine blank
• Power cable
• Documentation CD containing all of the documentation in Adobe
®
Portable
Document Format (PDF)
• Bar code labels
You will also need the following parts that were shipped with your rack:
• Eight clip nuts
• Eight rack screws