Quick Start Guide

14 Connecting SCSI, SAS, or Fibre Channel and Power Cables
SuperLoader 3 Quick Start Guide
Figure 11 Cable Connectors
(SAS Tape Drive)
Figure 12 Cable Connectors
(SCSI Tape Drive)
If the supplied SCSI cable does not fit the connector on your SCSI host adapter, you
either have an incompatible SCSI host adapter or you need to purchase a cable adapter.
Contact your service representative or your SCSI host adapter manufacturer for
information.
4 Attach the terminator to the remaining SCSI connector on the back panel (see
figure 12) of the autoloader (if the autoloader is the last or only device on the SCSI
bus). Otherwise, attach the cable to the next device on the SCSI bus. Make sure that
the last device on the SCSI bus is properly terminated.
5 Attach one end of your Ethernet cable to the Ethernet port on the back panel of the
autoloader for remote management.
6 Attach the other end of the Ethernet cable to your host network port or router.
7 Attach the female connector of the power cable to the power connector on the back
panel of the autoloader.
8 Plug in the power cable to the nearest properly grounded power outlet.
Ethernet cable
SAS cable
SCSI terminator
SCSI cable
Ethernet cable