Quick Start Guide

Autoloader Panel Overviews 11
SuperLoader
Figure 7 Connecting Support
Brackets
7 Verify that the autoloader is level. Adjust as needed.
8 When the autoloader is level, tighten all screws securing the autoloader to the rack.
This includes the following:
• Four screws securing the autoloader tabs to the front rails.
• Four screws securing the support brackets to the rear rails.
• Four screws securing the autoloader brackets to the support brackets.
Autoloader Panel Overviews
The front panel allows you to configure the autoloader, enter commands, and obtain
status information.
Figure 8 Front Panel Overview
Screws
Support bracket
Autoloader bracket
1 Power switch
2 Mailslot
3 Front panel LEDs