User's Manual

Quantum SuperLoader 3: Magazine or Magazine Blank Replacement
6-68059-01 Rev A
October 2013
Replacing a Magazine 7
Figure 6 Tape access on a
Magazine
tape access
Removing a Magazine
Blank
Your autoloader comes equipped with either two magazines, or one magazine
and one magazine blank. The autoloader will not function without both
magazine bays equipped with either a magazine or a magazine blank.
1 Pull the magazine blank straight out.
2 Replace with another magazine blank or a cartridge magazine (see
Replacing a Magazine).
Replacing a Magazine
Replacing a Magazine 1 Insert the tapes removed from the old magazine into the new magazine.
2 Grasp the magazine by the handle with one hand and support it underneath
with the other hand.
3 Slide the magazine into the magazine bay. Make sure you position the
magazine correctly; it should slide smoothly.
Caution: Insert the magazine slowly to avoid damaging internal
components or the autoloader.
4 The magazine is correctly installed when you feel it click into place and the
front is flush with the front panel.