User's Manual

Chapter 5 Administration
Setting the Change Mode
Quantum SuperLoader 3 User’s Guide 77
To modify the change mode, scroll to the mode to which you
want to set the autoloader and press
Enter. Reboot to enable new
mode
appears on the LCD.
4 Press and hold the power button on the front panel until
System
Shutdown wait 60 sec
appears on the LCD. Power Off appears on the
LCD and the autoloader shuts off.
5 Press the power button again to power up the autoloader. The new
change mode is now in effect.
Sequential Mode
Operations 5
If you enable Sequential mode, you must use the Sequential Ops submenu
under the
Commands menu to operate the autoloader after you reboot.
•The
Start command allows you to load the first cartridge.
•The
Resume command allows you to continue from the next unused
slot, if a user stopped the cycle.
•The
Stop command allows you to stop the cycle.
To start
Sequential mode operation:
1 From the main menu, scroll to
Commands, and then press Enter.
2 From the
Commands menu, scroll to Sequential Ops, and then press
Enter.
3 From the
Sequential Ops menu, scroll to Start, and then press Enter.
Moving first tape to drive appears on the LCD.
To stop
Sequential mode operation:
1 From the main menu, scroll to
Commands, and then press Enter.
2 From the
Commands menu, scroll to Sequential Ops, and then press
Enter.
3 From the
Sequential Ops menu, scroll to Stop, and then press Enter.
Ejecting tape from drive appears on the LCD.
To resume
Sequential mode operation:
1 From the main menu, scroll to
Commands, and then press Enter.
2 From the
Commands menu, scroll to Sequential Ops, and then press
Enter.
3 From the
Sequential Ops menu, scroll to Resume, and then press
Enter. Moving next tape to drive appears on the LCD.