User's Manual
Chapter 5 Administration
Configuring the Autoloader
Quantum SuperLoader 3 User’s Guide 71
Fibre Channel Autoloader5
If you have an autoloader with a Fibre Channel tape drive, Fibre Channel
replaces
SCSI ID.
To set or change the Fibre Channel parameters:
1 If the main menu is not already visible, press
Enter.
2 On the main menu, scroll to
Configuration and press Enter.
3 On the
Configuration submenu, scroll to Fibre Channel and press
Enter.
4 Scroll to the parameter you want to set or change (
Set Topology, Set
FC Speed
, or Set Loop ID), then press Enter.
•
Set Topology allows you select Auto Negotiate, Loop, or P2P.
•
Set FC Speed allows you to select Auto Negotiate, 1 Gig, or 2 Gig.
•
Set Loop ID allows you to select a Loop ID of 0 – 127 (only if Loop
is selected with
Set Topology).
5 Press and hold the power button on the front panel when
Please
Cycle Power
displays on the LCD.
6
Power Off displays on the LCD, then the autoloader shuts off.
7 Press the power button again to power on the autoloader.
The new Fibre Channel parameters are now in effect.
Note: In a native Fibre Channel device, dynamic World Wide
Naming is supported.