User's Manual
Chapter 5 Administration
Configuring the Autoloader
Quantum SuperLoader 3 User’s Guide 70
SCSI Autoloader 5
Each SCSI device attached to a server or workstation must have a unique
SCSI ID. For the SCSI SuperLoader 3 autoloader, you need one
SCSI ID.
To set the SCSI ID:
1 If the main menu is not already visible, press
Enter.
2 On the main menu, scroll to
Configuration and press Enter.
3 On the
Configuration submenu, scroll to SCSI ID and press Enter.
4 Scroll to the number you want to set as the autoloader's SCSI ID, then
press
Enter. Cycle Power new SCSI ID displays on the LCD.
5 Press and hold the power button on the front panel until
System
Shutdown wait 60 sec
displays on the LCD. Power Off displays on the
LCD, then the autoloader shuts off.
6 Press the power button again to power on the autoloader.
The new SCSI ID is now in effect.
SAS Autoloader 5
If you have an autoloader with a SAS tape drive, SAS replaces SCSI ID.
To set or change the SAS parameters to enable or disable transport layer
retries:
1 If the main menu is not already visible, press
Enter.
2 On the main menu, scroll to
Configuration and press Enter.
3 On the
Configuration submenu, scroll to SAS Interface and press
Enter.
4 Scroll to the parameter you want to set or change (
Enable or Disable
transport layer retries
), then press Enter.
5 Press and hold the power button on the front panel when
Please
Cycle Power
displays on the LCD.
6
Power Off displays on the LCD, then the autoloader shuts off.
7 Press the power button again to power on the autoloader.
The new SAS parameters are now in effect.