User's Manual

Chapter 4 On-board Remote Management
Commands Page
Quantum SuperLoader 3 User’s Guide 64
Commands Page
You can move tapes, run a system inventory, reset the picker to its home
position, or perform sequential operations from the
Commands page.
When you click
Commands, the page displays.
From a remote location, you can request that a tape be moved from one
position to another. To move a tape:
1 From any page, click the
Commands heading. The Commands screen
displays.
2 From the
Moving Tapes section of the page, click the drop-down
menu under
From: and select the current location of the tape that you
want to move.
3 From the drop-down menu under
To:, select the location to which
you want to move the tape, and then click
submit.
Inventory 4
The autoloader automatically runs an inventory whenever you power it
on or insert a magazine. If you need to run an inventory in addition to
this, you can use On-board Remote Management to do it remotely. To
run an inventory:
1 From any page, click the
Commands heading. The Commands screen
displays.
2 From the
Commands page, click Inventory. The autoloader starts an
inventory immediately.
Set to Home 4
If the autoloader is not able to successfully execute a Moving Tapes or an
Inventory command, try executing a Set to Home command, and then
retry the move or inventory command again.
The
Set to Home command resets the autoloader as a means to help the
autoloader recover from an unexpected internal condition. To set to
Home:
Note: You can also click the slot on the graphic of the autoloader
magazine to select and move a cartridge.