User's Manual

Chapter 3 Operating the Autoloader
Using Cartridges
Quantum SuperLoader 3 User’s Guide 33
Moving a Single
Cartridge 3
You can easily move a single cartridge from one location to another
inside the autoloader.
1 From the main menu, scroll to
Commands, and then press Enter.
2 From the
Commands submenu, scroll to Move, and then press Enter.
The
Move screen displays under From:. Scroll to the current location
of the cartridge you want to move. Slots that are occupied by a data
cartridge are indicated by an asterisk (
*).
3 From To:, scroll to the location to which you want to move the
cartridge. Slots that are occupied by a data cartridge are indicated by
an asterisk (
*). Press Enter.
4 Press
Enter.
If you select an empty location,
No Source Element displays on the
LCD. Choose a different location.
If you select a location that is already occupied,
Destination Full
displays on the LCD. Choose a different location.
Ejecting a Single
Cartridge 3
When you want to remove a single cartridge from the autoloader, you
can specify the cartridge you want by bar code or location, or choose the
cartridge currently in the tape drive.
To eject a cartridge by bar code (if you have a bar code reader):
1 From the main menu, scroll to
Commands, and then press Enter.
2 From the
Commands submenu, scroll to Eject, and then press Enter.
3 From the
Eject submenu, scroll to Tape, scroll to Mailslot, and then
press
Enter.
4 Scroll to
By Barcode.
A bar code label displays.
5 Scroll to the label that corresponds to the cartridge you want to eject.
Press
Enter.
To eject a cartridge by location:
1 From the main menu, scroll to
Commands, and then press Enter.
2 From the
Commands submenu, scroll to Eject, and then press Enter.