User's Manual

Chapter 3 Operating the Autoloader
Using Cartridges
Quantum SuperLoader 3 User’s Guide 32
4 Once you have inserted the cartridge, press Enter.
5 Press
Exit to clear the command and return to the menu.
To insert a cartridge into a magazine slot:
1 From the main menu, scroll to
Commands, and then press Enter.
2 From the
Commands submenu, scroll to Enter, and then press Enter.
3 From the
Enter submenu, scroll to To Location, and then press Enter.
The message
Insert Tape, Push Until Prompted displays on the LCD.
4 Once you have inserted the cartridge, press
Enter.
5 Press
Exit to clear the command and return to the menu.
Note: For the autoloader, push the cartridge in until it stops. The
cartridge will be about 3 inches (7.5 cm) inside the mailslot.
This may require that you push and have your fingers well
within the mailslot opening. After insertion, the end of the
cartridge will be visible at the back of the mailslot opening.
Note: If the insert cartridge function fails, the cartridge ejects and
you will have to repeat steps 3
and 4 again. The message
Missed Tape displays.
Note: After
Insert Tape, Push Until Prompted displays on the
LCD, insert the cartridge. After approximately 5 seconds,
the system automatically verifies that a cartridge is
inserted and continues the process. The message
Tape
Loaded
displays when successfully completed.
Note: For the autoloader, push the cartridge in until it stops. The
cartridge will be about 3 inches (7.5 cm) inside the
mailslot. This may require that you push and have your
fingers well within the mailslot opening. After insertion,
the end of the cartridge will be visible at the back of the
mailslot opening.
Note: If the insert cartridge function fails, the cartridge ejects
and you will have to repeat steps 3
and 4 again. The
message
Missed Tape displays.