User's Manual

Chapter 2 Installation and Configuration
Connecting Cables
Quantum SuperLoader 3 User’s Guide 18
Connecting Cables
Connecting SCSI and
Power Cables 2
To connect the SCSI and power cables to the autoloader, follow these
steps:
1 Shut down and turn off the selected server. Turn off all attached
accessory devices, such as printers and other SCSI devices.
2 Attach one end of the SCSI cable (included in the accessory kit) to one
of the connectors on the back panel of the autoloader (see figure3
).
Figure 3 Cable Connectors
(SCSI Tape Drive)
3 Attach the other end of the SCSI cable to the connector on the SCSI
host adapter or to the connector on the previous device on the SCSI
bus.
If the supplied SCSI cable does not fit the connector on your SCSI host
adapter, you either have an incompatible SCSI host adapter or you need
to purchase a cable adapter. Contact your service representative or your
SCSI host adapter manufacturer for information.
SCSI terminator
Ethernet cable
SCSI cable