User's Manual

Chapter 7 Customer Replaceable Units (CRUs)
Rack Mounting the Autoloader
Quantum SuperLoader 3 User’s Guide 101
b Install four screws (two per side) to secure the support brackets
to the autoloader brackets (see figure 18
).
Figure 18 Connecting Support
Brackets
7 Verify that the autoloader is level. Adjust as needed.
8 When the autoloader is level, tighten all screws securing the
autoloader to the rack. This includes the following:
• Four screws securing the autoloader tabs to the front rails.
• Four screws securing the support brackets to the rear rails.
• Four screws securing the autoloader brackets to the support
brackets.
Autoloader
Support bracket
bracket
Screws