User's Manual
Chapter 6 Diagnostics
Diagnostic Tests from the Front Panel
Quantum SuperLoader 3 User’s Guide 86
Front Panel Diagnostic
Tests 6
You can perform the following using the front panel:
• Tape Alert Logs
• End Curr. Test
•Picker Test
• Magazine Test
•Inventory Test
• Random Moves Test
• Last Test Log
To perform any of the front panel diagnostic tests:
1 From the main menu, scroll to
Diagnostics and press Enter.
2 Scroll to the test that you want to run and press
Enter.
If you are already logged in as Administrator, the test begins
executing immediately. The message
Running Test displays while the
test is in progress.
When the test completes, either the message
Test Successful displays
or the message
Test Failed and an error code displays. Proceed to step
4.
3 If you are not logged in, you will be asked to enter the
Administrator
password. Do the following:
a From the front panel, enter the
Administrator password by using
the
Up and Down scroll arrows to select each digit, and then press
Enter to move to the next digit. To move to the previous digit,
press
Escape. When you have entered the entire six digit
password, you will be asked to press
Enter one more time to
submit the password. If the password is incorrect, you will be
asked to re-enter it using the same procedure. Otherwise, you
will be returned to the
Diagnostics menu. Press Enter to run the
desired test.
The message
Running Test displays while the test is in progress.
To stop the test prematurely, see Stopping a Diagnostic Test
.
b When the test completes, either the message
Test Successful
displays or the message
Test Failed and an error code display.