User's Guide
Table Of Contents
- Preface
- Theory of Operation
- Media Changer Commands
- Overview of Command and Status Processing
- Media Changer Command Descriptions
- Initialize Element Status Command (07h)
- Inquiry Command (12h)
- Load Unload Command (1Bh)
- Log Sense Command (4Dh)
- Mode Select (6) / (10) Command (15h / 55h)
- Mode Sense (6) / (10) Command (1Ah/ 5Ah)
- Move Medium Command (A5h)
- Persistent Reserve In Command (5Eh)
- Persistent Reserve Out Command (5Fh)
- Position to Element Command (2Bh)
- Prevent/Allow Medium Removal (1Eh)
- Read Buffer Command (3Ch)
- Read Element Status Command (B8h)
- Release Element (10) Command (57h)
- Release Unit (6) Command (17h)
- Report Device Identifier Command (A3h)
- Report LUNS Command (A0h)
- Request Sense Command (03h)
- Reserve Element (10) Command (56h)
- Reserve Element (6) Command (16h)
- Send Diagnostic Command (1Dh)
- Set Device Identifier Command (A4h)
- Test Unit Ready Command (00h)
- Write Buffer Command (3Bh)
- Index
Chapter 2 Media Changer Commands
Persistent Reserve In Command (5Eh)
Quantum SuperLoader 3 Software Interface Guide 69
Persistent Reserve In Command (5Eh)
The PERSISTENT RESERVE IN command is a 10-byte command used to
obtain information about persistent reservations and registrations that
are active within a device server. It is used in conjunction with the
PERSISTENT RESERVE OUT command.
The following figure illustrates the format of the
PERSISTENT RESERVE
IN
command; the table that follows explains the data fields of the
command.
Figure 45 Persistent Reserve
In Descriptor Block
Note: Support for Persistent Reserve is drive type dependent. See
individual drive documentation for complete details.
Bit
Byte765 4 3210
0
Operation Code (5Eh)
1
Reserved Service Action
2 - 6
Reserved
7 – 8
(MSB)
Allocation Length
(LSB)
9
Unused Reserved Flag Link