User's Guide
Table Of Contents
- Preface
- Theory of Operation
- Media Changer Commands
- Overview of Command and Status Processing
- Media Changer Command Descriptions
- Initialize Element Status Command (07h)
- Inquiry Command (12h)
- Load Unload Command (1Bh)
- Log Sense Command (4Dh)
- Mode Select (6) / (10) Command (15h / 55h)
- Mode Sense (6) / (10) Command (1Ah/ 5Ah)
- Move Medium Command (A5h)
- Persistent Reserve In Command (5Eh)
- Persistent Reserve Out Command (5Fh)
- Position to Element Command (2Bh)
- Prevent/Allow Medium Removal (1Eh)
- Read Buffer Command (3Ch)
- Read Element Status Command (B8h)
- Release Element (10) Command (57h)
- Release Unit (6) Command (17h)
- Report Device Identifier Command (A3h)
- Report LUNS Command (A0h)
- Request Sense Command (03h)
- Reserve Element (10) Command (56h)
- Reserve Element (6) Command (16h)
- Send Diagnostic Command (1Dh)
- Set Device Identifier Command (A4h)
- Test Unit Ready Command (00h)
- Write Buffer Command (3Bh)
- Index
Chapter 2 Media Changer Commands
Move Medium Command (A5h)
Quantum SuperLoader 3 Software Interface Guide 68
If the Source Address element is empty, the target shall return CHECK
CONDITION
status. The sense key shall be ILLEGAL REQUEST and the
additional sense code
Medium Source Element Empty. If the Destination
Address
element is full, and different from the Source Address element,
the target shall return
CHECK CONDITION status. The sense key shall be
ILLEGAL REQUEST and the additional sense code Medium Destination
Element Full
.
Table 32 Move Medium
Command
The device capabilities MODE SENSE page provides a matrix with the
supported source element or destination element combinations for the
MOVE MEDIUM command.
Field Name Description
Medium
Transport
Address
Must be set to 0. Specifies the medium transport
element that is to be used in executing this
command.
Source Address
Destination
Address
These fields can be any valid element address. If
it is not valid, the media changer shall return
CHECK CONDITION status. The sense key shall be
ILLEGAL REQUEST and the additional sense code
INVALID ELEMENT ADDRESS.
INV Must be set to 0. Inverting and rotating are not
supported.