User's Guide
Table Of Contents
- Preface
- Theory of Operation
- Media Changer Commands
- Overview of Command and Status Processing
- Media Changer Command Descriptions
- Initialize Element Status Command (07h)
- Inquiry Command (12h)
- Load Unload Command (1Bh)
- Log Sense Command (4Dh)
- Mode Select (6) / (10) Command (15h / 55h)
- Mode Sense (6) / (10) Command (1Ah/ 5Ah)
- Move Medium Command (A5h)
- Persistent Reserve In Command (5Eh)
- Persistent Reserve Out Command (5Fh)
- Position to Element Command (2Bh)
- Prevent/Allow Medium Removal (1Eh)
- Read Buffer Command (3Ch)
- Read Element Status Command (B8h)
- Release Element (10) Command (57h)
- Release Unit (6) Command (17h)
- Report Device Identifier Command (A3h)
- Report LUNS Command (A0h)
- Request Sense Command (03h)
- Reserve Element (10) Command (56h)
- Reserve Element (6) Command (16h)
- Send Diagnostic Command (1Dh)
- Set Device Identifier Command (A4h)
- Test Unit Ready Command (00h)
- Write Buffer Command (3Bh)
- Index
Chapter 2 Media Changer Commands
Move Medium Command (A5h)
Quantum SuperLoader 3 Software Interface Guide 67
Move Medium Command (A5h)
The MOVE MEDIUM command requests that the SuperLoader 3 move a
volume from a source element to a destination element.
Figure 44 Move Medium
Descriptor Block
Bit
Byte7654321 0
0
Operation Code (A5h)
1
Logical Unit Number Reserved
2-3
(MSB)
Medium Transport Address
(LSB)
4-5
(MSB)
Source Address
(LSB)
6-7
(MSB)
Destination Address
(LSB)
8-9
Reserved
10
Reserved INV
11
Unused Reserved Flag Link