User's Guide
Table Of Contents
- Preface
- Theory of Operation
- Media Changer Commands
- Overview of Command and Status Processing
- Media Changer Command Descriptions
- Initialize Element Status Command (07h)
- Inquiry Command (12h)
- Load Unload Command (1Bh)
- Log Sense Command (4Dh)
- Mode Select (6) / (10) Command (15h / 55h)
- Mode Sense (6) / (10) Command (1Ah/ 5Ah)
- Move Medium Command (A5h)
- Persistent Reserve In Command (5Eh)
- Persistent Reserve Out Command (5Fh)
- Position to Element Command (2Bh)
- Prevent/Allow Medium Removal (1Eh)
- Read Buffer Command (3Ch)
- Read Element Status Command (B8h)
- Release Element (10) Command (57h)
- Release Unit (6) Command (17h)
- Report Device Identifier Command (A3h)
- Report LUNS Command (A0h)
- Request Sense Command (03h)
- Reserve Element (10) Command (56h)
- Reserve Element (6) Command (16h)
- Send Diagnostic Command (1Dh)
- Set Device Identifier Command (A4h)
- Test Unit Ready Command (00h)
- Write Buffer Command (3Bh)
- Index
Chapter 2 Media Changer Commands
Mode Select (6) / (10) Command (15h / 55h)
Quantum SuperLoader 3 Software Interface Guide 47
Figure 32 Mode Select Page
Descriptor
Table 23 Mode Select Page
Descriptor
Bit
Byte76543210
0
PS (0) 0 Page Code
1
Additional Page Length
2 - n
Page-Defined or Vendor Specific Parameter List
Field Name Description
PS
Parameters Savable. For the MODE SELECT (6) (10)
commands, this field is reserved (0).
Additional Page
Length
Indicates number of bytes in that page (not
including bytes 0 and 1).
Page-Defined or
Vendor Specific
Parameter List
Information in this field depends on the mode
page. Refer to “
Element Address Assignment
Page” on page 56 to “Device Capabilities Page”
on page 60.