User's Guide
Table Of Contents
- Preface
- Theory of Operation
- Media Changer Commands
- Overview of Command and Status Processing
- Media Changer Command Descriptions
- Initialize Element Status Command (07h)
- Inquiry Command (12h)
- Load Unload Command (1Bh)
- Log Sense Command (4Dh)
- Mode Select (6) / (10) Command (15h / 55h)
- Mode Sense (6) / (10) Command (1Ah/ 5Ah)
- Move Medium Command (A5h)
- Persistent Reserve In Command (5Eh)
- Persistent Reserve Out Command (5Fh)
- Position to Element Command (2Bh)
- Prevent/Allow Medium Removal (1Eh)
- Read Buffer Command (3Ch)
- Read Element Status Command (B8h)
- Release Element (10) Command (57h)
- Release Unit (6) Command (17h)
- Report Device Identifier Command (A3h)
- Report LUNS Command (A0h)
- Request Sense Command (03h)
- Reserve Element (10) Command (56h)
- Reserve Element (6) Command (16h)
- Send Diagnostic Command (1Dh)
- Set Device Identifier Command (A4h)
- Test Unit Ready Command (00h)
- Write Buffer Command (3Bh)
- Index
Chapter 2 Media Changer Commands
Log Sense Command (4Dh)
Quantum SuperLoader 3 Software Interface Guide 36
Figure 21 Log Parameters for
Device Wellness Log Sense
2
DU DS TSD ETC TMC Rsv’d LP
3
Parameter Length (0Ch)
4-7
(MSB)
Time Stamp
(LSB)
8 - 9
(MSB)
Source Element
(LSB)
10 - 11
(MSB)
Destination Element
(LSB)
12
Sense Key
13
Additional Sense Code
14
Additional Sense Code Qualifier
15
Additional Error Information
Field Name Description
Parameter
Code
Parameter Codes 0000h through 000Fh are supported. This provides 16 log
entries for error information capture.
DU
Disable Update. Always 0.
DS
Save not supported, always 1.
Bit
Byte76543210