User's Guide
Table Of Contents
- Preface
- Theory of Operation
- Media Changer Commands
- Overview of Command and Status Processing
- Media Changer Command Descriptions
- Initialize Element Status Command (07h)
- Inquiry Command (12h)
- Load Unload Command (1Bh)
- Log Sense Command (4Dh)
- Mode Select (6) / (10) Command (15h / 55h)
- Mode Sense (6) / (10) Command (1Ah/ 5Ah)
- Move Medium Command (A5h)
- Persistent Reserve In Command (5Eh)
- Persistent Reserve Out Command (5Fh)
- Position to Element Command (2Bh)
- Prevent/Allow Medium Removal (1Eh)
- Read Buffer Command (3Ch)
- Read Element Status Command (B8h)
- Release Element (10) Command (57h)
- Release Unit (6) Command (17h)
- Report Device Identifier Command (A3h)
- Report LUNS Command (A0h)
- Request Sense Command (03h)
- Reserve Element (10) Command (56h)
- Reserve Element (6) Command (16h)
- Send Diagnostic Command (1Dh)
- Set Device Identifier Command (A4h)
- Test Unit Ready Command (00h)
- Write Buffer Command (3Bh)
- Index
Chapter 2 Media Changer Commands
Log Sense Command (4Dh)
Quantum SuperLoader 3 Software Interface Guide 31
Move Statistics Page
(30h) 2
This page consists of the Log Page Header followed by a count of various
movements of cartridges within the system. The entries in the log page
are cumulative throughout the life of the unit and cannot be reset via
SCSI or power cycle. Log Parameters are not supported for this page.
Figure 17 Move Statistics
Format
Bit
Byte76543210
0
Reserved Page Code (30h)
1
Reserved
2 - 3
(MSB)
Page Length (18h)
(LSB)
4-7
(MSB)
Total Moves
(LSB)
8-11
(MSB)
Drive Loads
(LSB)
12-15
(MSB)
Mail Slot Imports
(LSB)
16-19
(MSB)
Mail Slot Exports
(LSB)