User's Guide
Table Of Contents
- Preface
- Theory of Operation
- Media Changer Commands
- Overview of Command and Status Processing
- Media Changer Command Descriptions
- Initialize Element Status Command (07h)
- Inquiry Command (12h)
- Load Unload Command (1Bh)
- Log Sense Command (4Dh)
- Mode Select (6) / (10) Command (15h / 55h)
- Mode Sense (6) / (10) Command (1Ah/ 5Ah)
- Move Medium Command (A5h)
- Persistent Reserve In Command (5Eh)
- Persistent Reserve Out Command (5Fh)
- Position to Element Command (2Bh)
- Prevent/Allow Medium Removal (1Eh)
- Read Buffer Command (3Ch)
- Read Element Status Command (B8h)
- Release Element (10) Command (57h)
- Release Unit (6) Command (17h)
- Report Device Identifier Command (A3h)
- Report LUNS Command (A0h)
- Request Sense Command (03h)
- Reserve Element (10) Command (56h)
- Reserve Element (6) Command (16h)
- Send Diagnostic Command (1Dh)
- Set Device Identifier Command (A4h)
- Test Unit Ready Command (00h)
- Write Buffer Command (3Bh)
- Index
Preface
Quantum SuperLoader 3 Software Interface Guide xv
Document Conventions
This manual uses the following conventions to designate specific
elements:
Element Convention Example
Abbreviations Lowercase, except where standard usage
requires uppercase
Mb (megabits)
MB (megabytes)
Acronyms Uppercase SCSI
Binary Notation Number followed by lowercase b 101b
Commands Uppercase (unless case-sensitive) FORMAT UNIT
Decimal Notation Number followed without suffix 101
Field Initial Caps (unless case-sensitive) Application Data
Hexadecimal Notation Number followed by h 101h
Sense Key Uppercase (unless case-sensitive) ILLEGAL REQUEST