User's Manual
Table Of Contents
- Contents
- Figures
- Tables
- Preface
- Tape Drive Product Information
- SDLT 600 Tape Drive Specifications
- Installing Your Tape Drive
- Warranty Note
- Safety, Handling, and ESD Protection
- Pre-Installation Guidelines
- Configuring and Installing an Internal Tape Drive with SCSI Interface
- Configuring and Installing an Internal Tape Drive with Fibre Channel Interface
- Configuring and Installing a Tabletop Tape Drive with SCSI Interface
- Configuring and Installing a Tabletop Tape Drive with SCSI Interface
- Confirming the Installation
- Using Your Tape Drive
- Regulatory Compliance
- Super DLTtape I and Super DLTtape II Data Cartridges
- DLTtape VS1 Data Cartridge
- Glossary
Chapter 3 Installing Your Tape Drive
Configuring and Installing a Tabletop Tape Drive with SCSI Interface
SDLT 600 Product Manual 60
Configuring and Installing a Tabletop Tape Drive with SCSI
Interface
3
This section provides instructions for configuring and installing the
tabletop SCSI model of the SDLT 600 tape drive.
Configuring the SCSI Tape
Drive
3
Figure 13 shows the location of the controls and connectors for the
tabletop tape drive. This model of tape drive is normally configured to
meet customer specifications before leaving the factory, so should not
require any internal configuration changes on site.
Figure 13 Rear Panel of the
SCSI Tabletop Model
SCSI
Connectors
Power
Switch
Power
Connector
SCSI ID
Selector
Fan