User's Manual
Table Of Contents
- Contents
- Figures
- Tables
- Preface
- Tape Drive Product Information
- SDLT 600 Tape Drive Specifications
- Installing Your Tape Drive
- Warranty Note
- Safety, Handling, and ESD Protection
- Pre-Installation Guidelines
- Configuring and Installing an Internal Tape Drive with SCSI Interface
- Configuring and Installing an Internal Tape Drive with Fibre Channel Interface
- Configuring and Installing a Tabletop Tape Drive with SCSI Interface
- Configuring and Installing a Tabletop Tape Drive with SCSI Interface
- Confirming the Installation
- Using Your Tape Drive
- Regulatory Compliance
- Super DLTtape I and Super DLTtape II Data Cartridges
- DLTtape VS1 Data Cartridge
- Glossary
Chapter 3 Installing Your Tape Drive
Configuring and Installing an Internal Tape Drive with SCSI Interface
SDLT 600 Product Manual 45
Figure 6 10-pin SCSI ID
Jumper Block on Rear of Tape
Drive
Table 26 SCSI ID Address
Selections (Tabular Format)
SCSI ID Jumper Across Pins
9-10* 7-8 5-6 3-4 1-2
010000
110001
210010
310011
410100
5
(default)
00000
610110
710111
811000
SCSI ID Jumper Block
(No jumpers on this block
selects default SCSI ID of 5)