User's Manual
Table Of Contents
- Contents
- Figures
- Tables
- Preface
- Tape Drive Product Information
- SDLT 600 Tape Drive Specifications
- Installing Your Tape Drive
- Warranty Note
- Safety, Handling, and ESD Protection
- Pre-Installation Guidelines
- Configuring and Installing an Internal Tape Drive with SCSI Interface
- Configuring and Installing an Internal Tape Drive with Fibre Channel Interface
- Configuring and Installing a Tabletop Tape Drive with SCSI Interface
- Configuring and Installing a Tabletop Tape Drive with SCSI Interface
- Confirming the Installation
- Using Your Tape Drive
- Regulatory Compliance
- Super DLTtape I and Super DLTtape II Data Cartridges
- DLTtape VS1 Data Cartridge
- Glossary
Chapter 2 SDLT 600 Tape Drive Specifications
Functional Specifications
SDLT 600 Product Manual 24
Table 14 Non-Operating
Vibration Specifications
(Packaged)
Application X,Y,Z axes Sweep rate = ½
octave/minute
Type Random
Frequency Range 10 to 500 Hz
Acceleration Level 2.0 G
PSD Envelope 0.008 G
2
/Hz
Application X,Y,Z axes Sweep rate = 60
minutes/axis
Vibration (Packaged)
Type Random
Frequency Range Truck Profile* (0.5 Grms)
Air Profile* (1.0 Grms)
Application X,Y,Z axes (30 minutes, each profile and each
axis, for a total of 3 hours)
Type Sine, Sweep, and Dwell
Frequency Range 5 to 150 to 5 Hz; 0.5 octave/minute, 0.5 G
Application X,Y,Z axes; dwell at lowest resonant
frequency in axis for 30 minutes.
Additional 30 minutes for each additional
resonance; up to 4 resonances total.
* Air and truck profiles are specified in ASTM D4728, Standard Test
Method for Random Vibration Testing of Shipping Containers.
Vibration (Unpackaged)