User's Manual
Table Of Contents
- Contents
- Figures
- Tables
- Preface
- Tape Drive Product Information
- SDLT 600 Tape Drive Specifications
- Installing Your Tape Drive
- Warranty Note
- Safety, Handling, and ESD Protection
- Pre-Installation Guidelines
- Configuring and Installing an Internal Tape Drive with SCSI Interface
- Configuring and Installing an Internal Tape Drive with Fibre Channel Interface
- Configuring and Installing a Tabletop Tape Drive with SCSI Interface
- Configuring and Installing a Tabletop Tape Drive with SCSI Interface
- Confirming the Installation
- Using Your Tape Drive
- Regulatory Compliance
- Super DLTtape I and Super DLTtape II Data Cartridges
- DLTtape VS1 Data Cartridge
- Glossary
Loading a Data Cartridge
SDLT 600 Product Manual 102
Loading a Data Cartridge 1
Complete this subsection to load a data cartridge into the front of the tape
drive; see figure 27
as needed.
1 Insert the data cartridge into the front of the tape drive, as shown in
figure 27
.
2 Push the data cartridge fully into the tape drive.
The Drive Status LED flashes to show that the media is loading.
When the media reaches the Beginning of Tape (BOT) marker, the
LED lights steadily. The data cartridge is now ready for use.
Figure 27 Loading a Super
DLTtape II Data Cartridge
Drive Status LED
Eject Button
Data Cartridge
Tape Drive