User`s guide

8 Turning the Library ON and Configuring Network Settings
Scalar i40 and Scalar i80 Quick Start Guide
Figure 5 Reinstalled
Components
Turning the Library ON and Configuring Network Settings
Caution: Before turning the library on, make sure you removed the shipping restraint
(4 thumbscrews, mylar sheet, metal clip) from the top of the library!
Otherwise, the library will not initialize. See Figure 2 on page 4.
1 Turn the library ON by pressing the power button on the front bezel (see Figure 6).
• The green power LED on the front panel above the power button illuminates,
and the LCD screen turns on. The library goes through a connection and
initialization sequence. This can take 5 to 17 minutes, depending on the size of
your library.
• The status LED on the rear of each drive sled turns green during initialization.
Ethernet
cable in LEFT
SCB port
Power supply cord
Service port –
do not use
Filler plate