User's Manual

Chapter 3 Configuring Your Library
Using the Setup Wizard
Scalar i500 User’s Guide 51
• You can return to the Setup Wizard from the web client.
• Any administrative users you create will also be able to use the Setup
Wizard from the web client as well as
Setup and Operations menu
commands to reconfigure the library.
• If necessary, you can cancel out of the
Setup Wizard on the operator
panel and begin using the library locally with the default settings in
place. If you accept the default network configuration settings, you
will not be able to access the library remotely from the web client.
You can, however, use
Setup > Network Mgmt on the operator panel at
any time to modify network settings. See Default Configuration
Settings on page 51 for more information.
Default Configuration
Settings 3
The default configuration settings are as follows:
•
License keys: COD, 41 slots minimum. The total number depends
on number of pre-activated slots purchased.
•
Network settings: DHCP enabled, IPv6 disabled
•
Import/export (I/E) station slots: 6
•
Cleaning cartridge slots: 0
•
Partitions: By default, the library creates partitions and assigns
available library resources proportionately among the partitions,
grouping tape drives according to distinct combinations of tape
drive interface type (SCSI, FC, or SAS) and tape drive vendor. To
mix tape drive types/vendors within a partition, create partitions
manually. See Manually Creating Partitions
on page 64.
See also About the Setup Wizard
on page 47.
Setup Wizard Tasks 3
As you work through the Setup Wizard screens, follow the on-screen
instructions.
The
Setup Wizard screens contains only a subset of all configuration
options. The
Setup and Operations menus contain most configuration
options, including those in the
Setup Wizard. This section includes
detailed descriptions of the configuration tasks, including how and when
to access them through the
Setup and Operations menus.
• Welcome (operator panel) — Welcomes you to the
Setup Wizard.