User's Manual

Chapter 7 Installing, Removing, and Replacing
Adding, Removing, and Replacing the I/O Fan Blade
Scalar i500 User’s Guide 318
Figure 31 on page 308 shows the FC I/O blade and I/O fan blade
installed side-by-side in the expansion module.
Adding an I/O Fan Blade7
These instructions explain how to add an I/O fan blade to your library.
You can add an I/O fan blade while the library is powered on.
Required tools: None
1 Access the back of the expansion module.
2 Remove the cover plate from blade bay to the right of the bay for the
FC I/O blade.
3 Press up and out to open the latch hooks on each side of the I/O fan
blade. The LED must be at the bottom of the blade.
Note: The recommended order of installing the FC I/O blade
and fan blade in an expansion module is starting from the
bottom two bays and moving up.