User's Manual

Chapter 7 Installing, Removing, and Replacing
Adding, Removing, and Replacing FC I/O Blades
Scalar i500 User’s Guide 312
4 Carefully align the FC I/O blade with the guide slots in the bay. The
status LEDs must be at the bottom.
5 Evenly apply pressure to both sides of the blade and slide it into the
expansion module until the latch hooks begin to move towards the
middle of the blade. Push the latch hooks towards the middle of the
1 FC I/O blade
2LEDs
3 Latch hooks, open
Caution: Forcing the blade into the bay can cause the pins to
bend.