User's Manual

Chapter 7 Installing, Removing, and Replacing
Removing and Replacing the Library Control Blade and LCB Compact Flash Card
Scalar i500 User’s Guide 279
18 Restore the library configuration (see Saving and Restoring the
Library Configuration on page 329). If you did not save a recent
configuration, you may need to manually restore your settings.
Replacing the LCB While
Retaining the Old
Compact Flash Card 7
These instructions explain how to replace the LCB while reusing the
existing LCB compact flash card.
Required tools: None
1 Power off the library.
2 Access the back of the library and locate the existing LCB.
3 Disconnect all cables from the existing LCB. You may want to label
each cable that is connected to the existing LCB to make sure that you
can correctly reconnect them to the new LCB.
4 Remove the existing LCB from the library.
To remove the existing LCB, release both of the LCB latch hooks and,
using the latch hooks as handles, pull the entire LCB toward you.
5 Remove the existing LCB compact flash card from the existing LCB.
Note: If your last saved configuration contained down-rev
library firmware, the library will restore the down-rev
firmware, overwriting the firmware you installed in Step
17.