User's Manual

Chapter 7 Installing, Removing, and Replacing
Removing and Replacing the Library Control Blade and LCB Compact Flash Card
Scalar i500 User’s Guide 278
8 After inserting the new LCB, secure it into the control module by
depressing both of the LCB latch hooks into the blade. The LCB will
fit snugly into its slot.
9 Reconnect all cables to the new LCB.
10 Power on the library.
The green power light on the front panel turns on. The screen may
remain dark for up to 5 minutes. Then an “Initialization In Progress”
screen displays.
11 Check the status of the LCB LEDs. All of its LEDs (blue, amber, and
green) should be solidly lit for a short period of time.
12 On the library’s operator panel, a screen appears with instructions on
how to proceed. Read the instructions and click
OK to close the
instruction screen.
13 When the login screen appears, login with user name
admin and
password
password.
14 Complete the next few screens to configure the host name and IP
address(es) for your library. You are prompted to choose whether to
enable IPv6. When you are finished configuring, click
Apply. A
progress window indicates the system is processing. When the
progress window indicates “success,” close the progress window.
15 The next screen lists one or more IP addresses assigned to the library.
Take note of the addresses, then click
Close. The system logs you out
of the operator panel and you return to the login screen.
16 Via an Internet browser, connect to your library using one of the IP
addresses assigned to the library in the previous step.
A screen appears on the web client with instructions on how to
upgrade library firmware.
17 Follow the onscreen instructions to upgrade library firmware to the
most recent version.
Firmware downloads are available at www.quantum.com/support
.
Note: The system defaults to DHCP. For IPv4 only, you can
deselect the DHCP option and assign a static IP address
(press the filled circle to the right of “
Use DHCP:” to
deselect). You cannot assign a static IP address for IPv6.