User's Manual

Chapter 7 Installing, Removing, and Replacing
Cable Management Guidelines
Scalar i500 User’s Guide 196
4 Plug the power cord into a power supply unit closest to the hook-
and-loop fastener.
5 Determine how much cord length you need to reach and easily plug
into the AC power source. Do not plug the cord into power source
until you are ready to power on the library.
6 If there is excess power cord, loop the excess cord into a bundle in the
shape of a figure-eight. The bundle should be small enough to hold
comfortably with one hand, or about eight inches in length.
7 Wrap the bundle with the hook-and-loop fastener. Thread the strap
through the plastic loop and tighten the strap around the bundled
cord. Secure the strap by pressing it down.
The power cord is now secured to the expansion module. Repeat these
steps to secure other power cords, if necessary. Bundle adjacent power
cords together using the same hook-and-loop fastener.
Once complete, power cord management for a 41U library should look
similar to Figure 24
on page 197.