User's Manual

Chapter 7 Installing, Removing, and Replacing
Cabling the Library
Scalar i500 User’s Guide 176
7 Power on the library.
a Turn on the rear power switch of each of the power supplies.
b Turn on the front power switch.
c Power up the host system.
8 Verify communication with all devices on the bus.
9 Configure the library using the commands on the operator panel. See
configuration information in Configuring Your Library
on page 47.
Connecting Library FC
Cables Directly to Host 7
Use this procedure, along with Figure 18 and Figure 19, if you are
installing a library that includes FC tape drives that are connected
directly to a host.