User's Guide
Table Of Contents
- SCSI Command Support
- SCSI Commands
- Initialize Element Status - 07h
- Initialize Element Status With Range - E7h
- Inquiry - 12h
- Log Sense - 4Dh
- Mode Select (6) - 15h
- Mode Select (10) - 55h
- Mode Sense (6) - 1Ah
- Mode Sense (10) - 5Ah
- Mode Pages
- Move Medium – A5h
- Persistent Reserve In – 5Eh
- Persistent Reserve Out – 5Fh
- Position to Element – 2Bh
- Prevent Allow Medium Removal – 1Eh
- Read Buffer – 3Ch
- Read Element Status – B8h
- Release Element (6) – 17h
- Release Element (10) – 57h
- Report LUNS – A0h
- Request Sense – 03h
- Request Volume Element Address - B5h
- Reserve Element (6) - 16h
- Reserve Element (10) - 56h
- Send Diagnostic - 1Dh
- Send Volume Tag - B6h
- Test Unit Ready (00h)
- Write Buffer (3Bh)
48 SCSI Commands
Move Medium CDB Format
The MOVE MEDIUM CDB format is shown in the following table.
Medium Transport Element Address – This field contains the address of the Medium Transport element
to use for the move. A value of 0001h is the address for all Medium Transport elements, but a value of 0000h
is also supported to select the default Medium Transport element.
Source Element Address – This field specifies the element address from where the cartridge is retrieved.
Destination Element Address – This field specifies the element address for where the cartridge is to be
placed.
Invert – This field must be set to 0 since the library does not support double-sided media.
Table 44 MOVE MEDIUM CDB format
Bit
Byte
76543210
0 Op Code (A5h)
1 Logical Unit Number Reserved
2
Medium Transport Element Address
3
4
Source Element Address
5
6
Destination Element Address
7
8
Reserved
9
10 Reserved Invert
11 Control