User's Guide
Table Of Contents
- SCSI Command Support
- SCSI Commands
- Initialize Element Status - 07h
- Initialize Element Status With Range - E7h
- Inquiry - 12h
- Log Sense - 4Dh
- Mode Select (6) - 15h
- Mode Select (10) - 55h
- Mode Sense (6) - 1Ah
- Mode Sense (10) - 5Ah
- Mode Pages
- Move Medium – A5h
- Persistent Reserve In – 5Eh
- Persistent Reserve Out – 5Fh
- Position to Element – 2Bh
- Prevent Allow Medium Removal – 1Eh
- Read Buffer – 3Ch
- Read Element Status – B8h
- Release Element (6) – 17h
- Release Element (10) – 57h
- Report LUNS – A0h
- Request Sense – 03h
- Request Volume Element Address - B5h
- Reserve Element (6) - 16h
- Reserve Element (10) - 56h
- Send Diagnostic - 1Dh
- Send Volume Tag - B6h
- Test Unit Ready (00h)
- Write Buffer (3Bh)
4 SCSI Command Support
The following table lists the parameters supported by the media changer device. The media changer device
does not support any diagnostic parameters.
Table 4 Media Changer Supported Parameters
Command Page Code
Inquiry Supported VPD Pages 00h
Inquiry Unit Serial Number Page 80h
Inquiry Device Identification Page 83h
Log Sense Supported Log Pages 00h
Log Sense Tape Alert Page 2Eh
Mode Sense Disconnect-Reconnect Page
1
02h
Mode Sense FC LU Control Page
1
18h
Mode Sense FC Port Control Page
1
19h
Mode Sense Informational Exceptions Control Page 1Ch
Mode Sense Element Address Assignment Page 1Dh
Mode Sense Transport Geometry Parameters Page 1Eh
Mode Sense Device Capabilities Page 1Fh
Mode Sense Return all pages 3Fh
1
If the library control path is provided by a tape drive, this page is provided by the tape drive.