User's Guide
Table Of Contents
- SCSI Command Support
- SCSI Commands
- Initialize Element Status - 07h
- Initialize Element Status With Range - E7h
- Inquiry - 12h
- Log Sense - 4Dh
- Mode Select (6) - 15h
- Mode Select (10) - 55h
- Mode Sense (6) - 1Ah
- Mode Sense (10) - 5Ah
- Mode Pages
- Move Medium – A5h
- Persistent Reserve In – 5Eh
- Persistent Reserve Out – 5Fh
- Position to Element – 2Bh
- Prevent Allow Medium Removal – 1Eh
- Read Buffer – 3Ch
- Read Element Status – B8h
- Release Element (6) – 17h
- Release Element (10) – 57h
- Report LUNS – A0h
- Request Sense – 03h
- Request Volume Element Address - B5h
- Reserve Element (6) - 16h
- Reserve Element (10) - 56h
- Send Diagnostic - 1Dh
- Send Volume Tag - B6h
- Test Unit Ready (00h)
- Write Buffer (3Bh)
94 SCSI Commands
Buffer Offset – This field indicates the starting location (byte offset) within the specified buffer to write data.
The initiator should conform to the offset boundary requirements returned in the READ BUFFER descriptor
described in “Read Buffer Response.”
Parameter List Length – If applicable, this field should be set to indicate the amount of data being written.