User's Manual

6-68027-01 Rev A, October 2013

*6-68027-01 A*

Scalar, DXi, StorageCare, StorNext, GoProtect, and Vision are registered trademarks of Quantum Corporation and its affiliates

in the United States and/or other countries. All other trademarks are the property of their respective owners. Quantum

specifications are subject to change.

Quantum Scalar i500 Upper

Network Blank Plate

Installation and Removal

Follow the steps in this document to replace an upper network blank plate in

your Scalar i500:

To replace the upper network blank plate, refer to the following sections:

• Installing the Upper Network Blank Plate on page 2

• Removing the Upper Network Blank Plate on page 2

The image below shows the location of the upper network blank plate:

Upper network

blank plate

Module

terminator

PAGE 1
Quantum Scalar i500 Upper Network Blank Plate Installation and Removal Follow the steps in this document to replace an upper network blank plate in your Scalar i500: To replace the upper network blank plate, refer to the following sections: • Installing the Upper Network Blank Plate on page 2 • Removing the Upper Network Blank Plate on page 2 The image below shows the location of the upper network blank plate: Module terminator Upper network blank plate © 2013 Quantum Corporation. All rights reserved.
PAGE 2
Quantum Scalar i500: Upper Network Blank Plate Installation and Removal 6-68027-01 Rev A October 2013 Installing the Upper Network Blank Plate To install the upper network blank plate: 1 Remove the module terminator from the port next to the network slot that you want to cover. 2 Slide the two tabs of the upper network blank plate into the bottom of the port slot. Push downward on the upper network blank plate until it fully seats in the slot.