User's Guide

Chapter 12 Installing, Removing, and Replacing
Installing the Library in a Rack
Scalar i500 User’s Guide 430
5 If you are only installing one module (a control module5U Library
Control Module), unpark the robot assembly now. For instructions,
see step 1 on page 336. If you are installing more modules, proceed to
the next step and do not unpark the robot assembly yet.
6 Close the module’s doors.
7 Install the remaining modules of your library (if any), following the
instructions in Installing Additional Modules Into the Rack
on
page 431.
8 Reinstall the tape drives, power supplies, and tape cartridges in the
library.
9 Cable your library as necessary, following the instructions provided
in Cabling the Library
on page 289.
10 Power on the library.