User's Guide

Chapter 6 Storage Networking
Configuring Data Path Failover
Scalar i500 User’s Guide 156
Figure 21 HP LTO-5 Fibre
Channel Tape Drive Ports
2 From the library Setup menu, click Drive Settings.
The
Setup - Drive Settings page displays (see Figure 22).
3 For each tape drive on which you want to enable data path failover,
do the following:
a First, change the
Requested Topology setting to Point to Point.
b Then select the
DPF check box.
4 Click
Apply.
Port 1 – default
data path
Port 2 – default
failover port
Port 1 Status LED
Port 2 Status LED