User's Manual

Chapter 4: Configuring the Library
Adding or Upgrading Licensable Features
70 Quantum Scalar i40 and Scalar i80 User’s Guide
3 On your library, locate the serial number. You will need the serial
number to retrieve your license key from the Web site. To locate the
serial number:
• On the operator panel, select Reports > About Library.
• On the Web client, select R
eports > About > Scalar i40/i80.
4 Access the license key Web site:
http://www.quantum.com/
licensekeys.
5 Enter
the information requested on the screen to obtain your license
key.
You are now ready to apply the lice
nse key to the library. See Applying a
License Key on page 70.
Applying a License Key A license key may be applied to the library during the initial
configuration or whenever licensed features are purchased.
Caution: While you are installing a license key, backup operations
may be interrupted.
Operator Panel
Entering a license key on the operator panel is difficult. It is
recommended that you use the Web client, if possible.
1 Selec
t Setup > License Installation.
The screen displays your cu
rrent licenses.
2 Press Add.
Five blank digits appear on the scree
n. The first digit is highlighted.
3 Use the Up and Down buttons t
o scroll through the list of letters
and numbers until the first number appears. Press the Right button
to advance to the next digit. Repeat for the remaining digits.
4 When
all the digits are entered correctly, press Apply.
5 Press OK.
6 Save
the library configuration (see Saving the Library Configuration
on page 101).