User's Manual

Chapter 8: Installing, Removing, and Replacing Components
Removing and Replacing the System Control Board
Quantum Scalar i40 and Scalar i80 User’s Guide 227
3 When initialization is complete, the Library Installation screen
appears on the operator panel, displaying the text, “The library
needs to have its IP Address configured.” The purpose of this screen
is to set the IP address so you can access the library via the Web
client and download firmware. (After you have loaded firmware,
you can change or reconfigure IP addresses if needed.)
4 Press Next.
The screen displays the text, “Current protocol: IPv4. Set protocol to
IPv6?”
5 Selec
t Yes or No.
•If you select Ye
s, the library assigns an IPv6 address.
•If you select No, you are prompt
ed to select DHCP or assign a
static IP address. If you choose to assign a static IP address, use
the Up and Down buttons to set the numeric value for each
digit, and press the Right button to go to the next digit. When
finished, press Apply. If you choose DHCP, the library assigns an
IPv4 address.
6 When
finished viewing or setting the IP address, press Next.
The newly assigned IP address displays on the screen.
7 T
ake note of the IP address.
8 Downl
oad the latest library firmware to a known location on your
computer. Library firmware is available at
http://
www.quantum.com. Navigate to the appropriate firmware version
and download the firmware image file.
9 Open
an Internet session and enter the library IP address listed on
the operator panel into the Web browser.
The Web client displays a screen instructing you to
select the
firmware image you want to load on the library.
10 Click Bro
wse and select the firmware image you downloaded to
install on the library.
11 Click OK, then click OK
again to agree to restart the library.
The Web client displays the following message:
Decoding installation bundle...done.
Validating bundle...good.
Installing firmware...library will
reboot when complete.