User's Manual

Chapter 8: Installing, Removing, and Replacing Components
Removing and Replacing a Magazine
Quantum Scalar i40 and Scalar i80 User’s Guide 219
6 Turn the magazine over and install the two washers and two M3
screws securing the bottom of the bezel to the magazine. Install
them in the outer hole in each tab (see
Figure 55).
Figure 55 Removing/Installing
the Magazine Bezel
Bezel
Tab
7 Remove the tape cartridges from the removed magazine and
carefully install them in the exact same slots in the replacement
magazine. Use the map you created if necessary.
8 Slide the magazine into the magazine slot all the way until it stops.
The li
brary performs an inventory on the replaced magazine.
9 Wait for the library to finish its inventory.