User's Manual

Chapter 8: Installing, Removing, and Replacing Components
Removing and Replacing a Magazine
216 Quantum Scalar i40 and Scalar i80 User’s Guide
• (4) M3 x 6 Phillips head screws
• (4) washers
Creating a Backup Map
of Cartridge Locations
When you transfer tape cartridges from the removed magazine into the
replacement magazine, each cartridge needs to go in the same slot
position it was in previously. One way to do this is to transfer the
cartridges one by one from one magazine to the other. However, if the
cartridges get mixed up or dropped, you need a backup method to
know where to place your cartridges. The library configuration report
provides a convenient backup “map.”
1 On
the Web client, select Rep
orts > Library Configuration.
2 Click the Show Barcodes button.
The screen displays a map of the li
brary showing the location of
each cartridge, by barcode.
3 Click the “print” icon in the upper right cor
ner to print the report.
Alternatively, take a screen capture of the report and save or print it,
or copy the map by hand.
Removing the
Magazine from the
Library
You can perform this procedure with library power on.
1 From the operator panel, select Acti
ons > Magazine.
2 Use the Up and Down buttons to
select the magazine you want to
remove and press Release.
3 Wait for the operator panel to display the message: “Magazine is
no
w unlocked. Waiting for the magazine to be moved to the
expected position.”
4 Pull the magazine bezel out and remove the magazine from the
li
brary. If you do not remove the magazine within 30 seconds, the
magazine locks again.