User's Manual

Chapter 8: Installing, Removing, and Replacing Components
Removing the Library from a Desktop Kit
Quantum Scalar i40 and Scalar i80 User’s Guide 197
8 Install the top cover as follows (see Figure 45):
a Slide the top
cover onto the library, from back to front. The back
of the top cover has two screw holes and overhangs the back of
the library.
b Install the two top cover screws through the top cover and into
the screw holes in the top of the side panels.
Figure 45 Installing the Top
Cover
9 Re-install the magazines and push them in until they close.
10 Re-install tape drives if you removed them previously.
11 Connect the tape drive cables, Ethernet cable, and power cord (see
Connecting Library Cables on page 173).
Removing the Library from a Desktop Kit
To remove the library from a desktop kit, reverse the steps in Installing
the Library in a Desktop Kit on page 189.