User's Manual

Chapter 6: Getting Information About the Library
Using Advanced Reporting
156 Quantum Scalar i40 and Scalar i80 User’s Guide
• Selected Partition — The report chart is based on an
individual partition in the physical library.
Note: See Installed Tape Drive Location Coordinates on
page 8 for an explanation of the location coordinates.
3 Click
Next.
The report is generated and appears on the screen.
Configuring the Media
Integrity Analysis
Report
1 From the library menu bar, select Reports > Advanced Reporting >
Media Integrity Analysis
.
The Media Integrity Analysis Report configuration page opens. This
may take several
minutes.
2 C
onfigure the report by specifying the following:
• Date Range — Specifies the range of time covered by the report.
Ch
oose Last 7 days; Last 4 weeks (default); Last 3 months; or All
History (as far back as there is data in the log file).
• Attributes— Specifies which values are included in the report,
and how they are com
bined. Select in any combination,
including all (default) and none. If you select no attributes, the
chart displays the Tape Alert count for the selected Grouping.
• Cartridge Barcode — All relevant tape cartridges.
• Drive Physical SN — All relevant tape drives.
• Tape Alert — The Tape Alert flags that were issued. For a
description of all T
ape Alert flags, see Appendix
B, TapeAlert
Flag Descriptions.
• Chart — How the data is displayed in the
chart. Choose Area,
Bar (default), Line, or Pie.
• Type — The chart type. Select one of the following:
• Rollup (default) — Displays the number of Tape Alerts for
the
combination of Grouping and Attributes you selected.
• Trend — Shows the occurrence of Tape Alerts over time.
• Grouping— Specifies which drive(s) or tape cartridge(s) on
whi
ch to base the report. Choose one of the following: