User's Manual

Chapter 6: Getting Information About the Library
Using Advanced Reporting
Quantum Scalar i40 and Scalar i80 User’s Guide 155
• Total Read and Write — The combined total amount of data
written to and read from each tape drive.
• Media Mount Count — The number of tape cartridge
mount
s.
• Media Mount Time — The total amount of time media
spent
in the selected drive(s).
• Media Motion Time — The total amount of time media
spent
in motion while in the tape drive (writing, reading,
rewinding, etc.).
• Chart — How the data is displayed in the
chart. Choose Area,
Bar (default), Line, or Pie.
• Type — The chart type. Select one of the following:
• Rollup (default) — Displays the Grouping on the x-axis and
the
Attribute amount on the Y-axis.
• Trend — Shows how the Attribute amount changes over
time for the selected Gr
ouping.
• Grouping — Specifies which tape drive(s) or partition(s) to
in
clude in the report. Select one of the following:
• All Drives by Coordinate (default) — Presents the sum total
of
the selected attribute for all tape drives according to their
location in the library. If more than one tape drive resided in
that location during the selected range, then the attribute
values for all the tape drives that resided in that location are
combined in the chart.
• All Drives by Physical SN — Presents the sum total of the
se
lected attribute for all drives according to the physical
tape drive serial number.
• All Partitions — Presents a comparison of all drives grouped
by parti
tion in the physical library.
• Selected Drive by Coordinate — The report chart is based on
an
individual tape drive location in the library. If more than
one tape drive resided in that location during the selected
range, then the attribute values for all the tape drives that
resided in that location are combined in the chart.
• Selected Drive by Physical SN — The report chart is based on
an individual
tape drive identified by its physical drive serial
number.